Different Methods of Geophysical Surveys Used in Mineral Prospecting
Reflection Seismology What it is Reflection Seismology (called “seismic” in the minerals industry) is the practice of inducing a vibration in the Earth’s surface, and analyzing the reflection. The vibration is induced using a vibration machine or a series of dynamite blasts. This creates a seismic wave that travels to the Earth’s mantle, the ball of molten rock below are feet. The mantle reflects the wave back up to the surface, where they are measured. What it is good for Hydrocarbons. Oil, gas, and coal occur in stratified sedimentary rock. This is because they were originally biomass, like forests or…
Read More
Post Comments (1) »Warning: Undefined array key 0 in /home/gemsysca/webtest.gemsys.ca/wp-content/themes/gemsystems/author.php on line 207
Requirements for Obtaining High Accuracy with Proton Magnetometers Part 5
Signal-to-Noise Ratio Limited S/N ratio will make measurement of the average period uncertain. Relative accuracy or repeatability of measurement, а prerequisite for absolute accuracy, depends to a large extent on S/N ratio of the obtained precession signal. Obviously, an effort must be made tо use all thе available information from the noisy precession signal, therefore usually all thе zero crossings are taken and used for calculation of the result. Sensor Cleanliness Obviously, any ferromagnetic inclusion in the sensor or its immediate vicinity may influence the field and cause erroneous result. Presence of AC Magnetic Fields AC magnetic fields caused by…
Read More
Warning: Undefined array key 0 in /home/gemsysca/webtest.gemsys.ca/wp-content/themes/gemsystems/author.php on line 207
Requirements for Obtaining High Accuracy with Proton Magnetometers Part 4
Method of Measurement Proton precession frequency is of acoustic range and the measurement interval varies from a fraction of a second tо few seconds. To achieve required resolutions of sub-ppm it is customary tо measure the average period of the precession frequency and convert it to the frequency and the magnetic field. Required accuracies arе achieved by measuring precession frequency to a small fraction of one period down to only few degrees or even a fraction of 1 degree of phase shift. This in turn means that the precession frequency must have a stable phase and good signal tо noise…
Read More
Warning: Undefined array key 0 in /home/gemsysca/webtest.gemsys.ca/wp-content/themes/gemsystems/author.php on line 207
Requirements for Obtaining High Accuracy with Proton Magnetometers Part 3
Time Reference Stability and Accuracy Measurement of frequency is one of the most precise measurements we can do, primary standards going into 10-13 or even better accuracy. In principle, therefore, there is no problem with the time reference for the counters measuring precession frequency. In practice, the situation is different. Due to higher costs and/or higher power requirements in the Observatory magnetometers we usually use tеmреrаturе compensated or at best thermally stabilized crystal oscillators with long term (1 yеar) stabilities of l ppm or similar. Latest development in global positioning systems allows for much better accuracies by locking or periodically…
Read More
Requirements for Obtaining High Accuracy with Proton Magnetometers Part 2
Gyromagnetic Constant The gyromagnetic constant relates the precession frequency and the magnetic induction or flux density. It is а real constant, i.e. the precession frequency of protons and the applied magnetic inductions are linearly related. Several institutions have been engaged in determination of the gyromagnetic constant: NIST (USA) National Institute of Standards and Technology formerly NBS NPL (UK) National Physical Laboratory VNIIM (Russia) Mendeleyew Institute of Metrology, St.Pеtеrsburg NIÐœ (China) National Institute of Metrology ASMW (former East Germany) Amt fur Standardisierung Messwesen and Wonenpufung, Berlin They came with their own results and accuracies, unfortunately often far apart from each other.…
Read More
Requirements for Obtaining High Accuracy with Proton Magnetometers Part 1
Definition of Absolute Accuracy Absolute accuracy of a measurement is the difference between measured and true values. Obviously, nobody knows the true value, so we end up defining the limits we know the true value must be within. Presently the limits of accuracy of measurement of the magnetic field of the Earth can be pushed to better than 1ppm. In a field of, say, 50,000nT, this is better than 0.05nT. However, there are numerous difficulties and conditions that must be fulfilled to obtain that kind of absolute accuracy. Parameters that are involved include: • Gyromagnetic constant’s accuracy • Time reference…
Read More
Warning: Undefined array key 0 in /home/gemsysca/webtest.gemsys.ca/wp-content/themes/gemsystems/author.php on line 207
New GPS Option Available
New GPS Option Available As of March31st, GEM is offering a new NovAtel GPS option which can be purchased with any of our instruments. NovAtel CORRECT™ positioning technology is now available with TerraStar’s precise point positioning (PPP) corrections. This system delivers 10 centimeter or better accuracy with no additional base station infrastructure. Along with this feature, other benefits include improved accuracy and performance of solutions. This option optimally combines data from numerous GNSS satellite constellations with corrections from a variety of sources, to deliver the best position solution possible. Image: Terrastar.net For more information on how this GPS…
Read More
Warning: Undefined array key 0 in /home/gemsysca/webtest.gemsys.ca/wp-content/themes/gemsystems/author.php on line 207
GEM’s Proton Precession Magnetometer
Proton Precession Magnetometers have long had a niche as inexpensive portable magnetometers, despite limitations such as relatively large power consumption and relatively low sensitivity. Typical applications include environmental and engineering surveys where targets are relatively near surface and do not require high sensitivities to detect and map, or production-oriented reconnaissance surveys for resource exploration. Operating Principles A proton magnetometer uses hydrogen atoms to generate precession signals. Liquids, such as kerosene, are used because they offer very high densities of hydrogen and are not dangerous to handle. A polarizing DC current is passed through a coil wound around a liquid sample…
Read More
Warning: Undefined array key 0 in /home/gemsysca/webtest.gemsys.ca/wp-content/themes/gemsystems/author.php on line 207
GEM Systems Upcoming Events From Around the World!
GEM Systems Upcoming Events From Around the World! With all of the advancements and innovations GEM Systems pioneers in the magnetometer industry, it’s important that we make our presence felt at the top events around the world. There are three upcoming events we are attending in three distinctly different regions that we are really looking forward to. Expomin – Santiago, Chile The Expomin event takes place in the South American city of Santiago, Chile from April 21 – 25, 2014. Santiago is the capital of Chile and it is more than 1,700 feet above sea level, with both mountains…
Read More
Warning: Undefined array key 0 in /home/gemsysca/webtest.gemsys.ca/wp-content/themes/gemsystems/author.php on line 207
Does Atlantis Exist?
You may know that GEM Systems’ equipment have been used to help assist modern day Indiana Joneses on exhausting archaeological digs. But did you know that researchers have also used our equipment on a hunt for the mythical lost city of Atlantis? Above is a rendering of the rings of Atlantis in Doñana Park, Spain that may have existed thousands of years ago. Image: nationalgeographic.com Our highly advanced magnetometers have been dispatched to the Doñana mud flats in Doñana National Park in southern Spain. There, the sensitive equipment was deployed at the survey site, with the sensors – some strapped…
Read More
Warning: Undefined array key 0 in /home/gemsysca/webtest.gemsys.ca/wp-content/themes/gemsystems/author.php on line 207
Categories
- All (139)
- General Category (23)
- Magnetometers (30)
- News & Events (102)
Recent Posts
- PDAC 2026 March 1 – 4th, Toronto
- Merry Xmas: Office Closed Dec 24 – Jan 4
- AGU2025, Dec 15-19, New Orleans
- EAGE NSG, 7-11 September, Naples
- Office closed July 1st, 2025
- EAGE 2025, June 2 – 5, Toulouse
- PDAC March 2 – 5, 2025
- 2024 Holiday Office Hours
- AGU2024: Dec 9th to 12th, Washington D.C.
- XXth IAGA, October 31 – November 6, 2024, Brazil
RSS Feeds
Archives
- February 2026
- December 2025
- September 2025
- July 2025
- May 2025
- January 2025
- December 2024
- October 2024
- June 2024
- April 2024
- February 2024
- January 2024
- December 2023
- October 2023
- June 2023
- February 2023
- December 2022
- October 2022
- August 2022
- June 2022
- May 2022
- December 2021
- November 2021
- October 2021
- December 2020
- January 2020
- December 2019
- October 2019
- September 2019
- August 2019
- May 2019
- March 2019
- February 2019
- January 2019
- December 2018
- November 2018
- October 2018
- September 2018
- August 2018
- July 2018
- May 2018
- April 2018
- February 2018
- January 2018
- December 2017
- October 2017
- September 2017
- August 2017
- June 2017
- May 2017
- April 2017
- February 2017
- January 2017
- December 2016
- September 2016
- August 2016
- July 2016
- June 2016
- March 2016
- February 2016
- December 2015
- October 2015
- May 2015
- April 2015
- March 2015
- February 2015
- January 2015
- December 2014
- November 2014
- October 2014
- September 2014
- August 2014
- July 2014
- June 2014
- May 2014
- April 2014
- March 2014